再生瀝青混凝土在進行馬歇爾配合設計時，原本使用AI MS-2理論以圖表手繪方式判斷黏滯度，本研究將手繪判定可能導致的誤差，改以公式計算，使用數值來研判，並由工廠添加再生劑實際拌合進行試驗室成效之探討。試驗結果添加再生劑在相同的條件下，對穩定值及間接張力並沒有太大的差異，對有添加再生劑對抗水份侵襲能力明顯較強，但仍未超過一般瀝青混凝土。添加的再生劑鑑於使用取得及成本的考量，建議使用中油AC-5等級瀝青。
近年來，再生瀝青混凝土鋪面品質陸續發生不良的現象，藉由本研究成效結果探討再生瀝青混凝土鋪面在實務上的問題，包含鋪面厚度、含油量、堆置場、工程需求、流向管制等方面進行分析。

When the recycled asphalt concrete carries on the Marshall mixture design , usually use graph hand painted decides Viscosity with AI MS-2 . This research the error which possibly causes the hand painted decision ,the use formula computation, the use value judges ,and discusses recycled asphalt concrete increase recycle agent, mixes actually in the factory carries on the laboratory result .Test result increase the recycle agent under same condition ,the stable value and the indirect tension test not too big difference, has to the recycled asphalt concrete increases recycle agent to be good to TSR ,but has still not surpassed general HMA .Regarding attains and the cost consideration about recycle agent ,suggested that uses Chinese Petroleum Corporation the AC-5 asphalt .
In the last few years , the road Pavement quality to the recycled asphalt concrete has the bad phenomenon one after another, Discusses the recycled asphalt concrete by way of this research result on the Practical question, contains the depth of pavement, asphalt content, to deposit the place, work quantity, to flow to aspects and so on control to carry on the analysis.

交通部台灣區國道新建工程局，(2009)「再生瀝青混凝土應用於公路工程之品管實務研究」，台北。
蔡攀鰲，(2003)「再生瀝青混凝土混合料之組成」，兩岸鋪面工程及再生瀝青混凝土特輯，第98-106頁。
姜榮彬，(2004)「瀝青材料」，中華鋪面工程學會，第191-200頁。
許慧玲，(2004)「分析回收瀝青添加再生劑之膠漿性質」，碩士論文，國立成功大學土木工程學系，台南。
翁國豪，(1996)「新鋪瀝青混凝土面層加速冷卻對抗車轍能力之影響研究」，碩士論文，國立成功大學土木工程學系，台南。
王正偉，(1999)「路面加鋪工程開放交通時機之研究」，碩士論文，中原大學，桃園。
張振成，(1999)「鋪面整修作業之開放交通因子研究 」，碩士論文，中原大學，桃園。
吳宗騂，(2005)「透水性鋪面溫度行為模式之初步探討」，碩士論文，逢甲大學交通工程與管理學系，台中。
許浩昇，(2001)「瀝青混凝土鋪面整修作業之開放交通時機之研究」，碩士論文，中原大學，桃園。
林宏偉，(2003)「瀝青混凝土鋪面加鋪作業溫降量測之開放交通時機研究」，碩士論文，國立中央大學土木工程研究所，桃園。
林東慶，(2004)「依據瀝青性質評估再生瀝青混凝土添加比例」，國立成功大學研究所碩士論文，台南。
Asphalt Institute, (1995).“Mix Design Method for Asphalt Concrete and Other Hot-Mix Types. MS-2”, Sixth Edition. Asphalt Institute, Lexington, Kentucky pp. 55-64 and pp.123-136.
Arrhenius, S., (1887) “The Viscosity of Aqueous Mixture,” Physical and Chemistry, Vol.1, pp.285-298.
Epps, J.A., Little, D.N., Holmgreen, R.J., and Terrel, R.L. (1980) “Guidelinesfor Recycling Pavement Materials,” CHRP Report 224.
Grunberg, L. and Nissan, A.H., (1949) “Mixture Law for Viscosity,” (letter)Nature , Vol.164, pp.799-800.
Roberts, F. L., Kandhal, P. S., Brown, E.R., Lee, D.Y., and Kennedy,T.W., (1996)”Hot Mix Asphalt Materials,Mixture Design, and Construction”,NAPA Education Foundation, Second Edition ,Lanham, Maryland.
Shell Bitumen, (1990) “The Shell Bitumen Handbook”, Shell Bitumen, UK,pp.91-95.
Mamlouk M. S., Witczak M. W., Kaloush K. E., and Hasan N. (2005). “Determinationof Thermal Properties of AsphaltMixtures”, J. Test. Eval, Vol. 33, pp. 1-9.
Yavuzturk C., and Ksaibati K. (2002). “Assessment of temperature fluctuations in asphalt pavements due to thermal environmental conditions using a two-dimensional, transient finite difference approach”, Laramie,U. S. A.,pp. 49-67.