| 研究生: |
呂習堯 Xi-Yao Lu |
|---|---|
| 論文名稱: |
邊牆射流及尾檻對砂質底床之沖刷研究 |
| 指導教授: |
周憲德
Hsien-Ter Chou |
| 口試委員: | |
| 學位類別: |
碩士 Master |
| 系所名稱: |
工學院 - 土木工程學系 Department of Civil Engineering |
| 畢業學年度: | 89 |
| 語文別: | 中文 |
| 論文頁數: | 94 |
| 中文關鍵詞: | 尾檻 、邊牆射流 、洩水閘門 、護坦 |
| 外文關鍵詞: | sill, wall jet, sluice gate, apron |
| 相關次數: | 點閱:12 下載:0 |
| 分享至: |
| 查詢本校圖書館目錄 查詢臺灣博碩士論文知識加值系統 勘誤回報 |
下射式洩水閘門是一般堰壩和灌排渠道常使用的水工結構物,當水流經洩水閘門形成邊牆射流,沖擊底床泥沙顆粒,再由懸浮載或底床載方式將顆粒攜離沖刷坑至下游堆積。此對水工結構物下游河床之淘刷,造成水工結構物基礎裸露,危及結構物本身之穩定和安全性。一般下游底床會有護坦和尾檻的保護工設施,以防止底床的淘刷。本研究著重在一固定之流量及閘門開口下,分別比較邊牆射流、邊牆射流護坦保護工及邊牆射流尾檻保護工等三種不同的試驗模型在不同尾水深度時,其沖刷坑的沖刷機制與型態。本文並比較尾檻保護工和護坦保護工下游端之沖刷坑,進一步瞭解保護工與在水流作用下,下游河床之互制作用,以做為最佳保護水工結構物設計之參考。
Aprons and sills are the common countermeasures for protecting the downstream riverbed. In the condition of homogeneous sand beds by wall jet, three models, which are the wall jet, the wall jet with apron, and the wall jet with end sill, are compared. By analyzing experimental data, a predicitive model is developed, and is used to explore the characteristics of local scour near those structures.
Ahmad, N. ” Mechanism of erosion below hydraulic works ” IAHR & ASCE , USA , pp.133-143 (1953).
Ali, K.H.M. & Lin, S. Y. “Local sour caused by submerged wall jets” Proc. Instn Civ. Engrs ,Part2 , No.81 , pp. 607-645(1986 ).
Farhoudi, J. & Smith , K. V. H. “Local scour profiles downstream of hydraulic jump” Journal of Hydraulic Research, Vol.23 , No.4 , pp. 343-358(1985).
Farhoudi, J. & Smith, K. V. H. “Time scale for scour downstream of hydraulic jump” Journal of Hydraulic Division, ASCE , Vol.108 , No.HY10 , pp. 1147-1162(1992).
Gunal, M. and Rangaswami, A. “ Hydraulic jump in sloping channels ” Journal of Hydraulic Engineering, ASCE , Vol.122 , No.8 , pp436-442(1996 ).
Hager, W. H. “ Incipient jump conditions for flow over a vertical sill ” Journal of Hydraulic Engineering, ASCE , Vol.122 , No.8 , pp.446-449(1996 ).
Hogg , A. J. , Huppert, H. & Dade, W. B. ,“Erosion by planar turbulent wall jets” Fluid Mech , Vol.338 , pp.317-340 (1997).
McCorquodale, J. A. & Khalifa, A. “Internal flow in hydraulic jumps” Journal of Hydraulic Engineering , ASCE , Vol.109 , No.5 , pp. 684-701(1983 ).
Ohtsu, I. & Yasuda, Y. “Hydraulic jump in sloping channels” Journal of Hydraulic Engineering , ASCE , Vol.117, No.7, pp905-921(1991).
Rajaratnam, N. “ Erosion by plane turbulent jets ” Journal of Hydraulic Research Vol.19 , No.4 , pp.339-358 (1981).
Rajaratnam , N. “ Erosion by submerged circular jets ” Journal of Hydraulic Division , ASCE , Vol.108 , No.HY2 , pp. 262-266(1982).
Rajaratnam, N & Murahari, V. “ Flow characteristics of sloping channel jumps ” Journal of Hydraulic Division , ASCE , Vol.100, No. HY6 , pp.731-740(1974 ).
Rajaratnam, N. & Wu, S “ Effect of baffles on submerged flow ” Journal of Hydraulic Engineering , ASCE , Vol.121 , No.9, pp.644-651 (1995).
Rajaratnam, N. & Subramanya, K. “ Profile of the hydraulic jump ” Journal of Hydraulic Division , ASCE , Vol.94 , No.HY3 , pp. 663-673(1968).
Rajaratnam, N. “ Erosion by plane turbulent jets ” Journal of Hydraulic Research , Vol.19 , No.4 , pp. 339-357(1981).
Rajaratnam, N. & Chamani, M . R. “ Characteristics of skimming flow over stepped spillways ” Journal of Hydraulic Engineering , ASCE , Vol.125 , No.4 , pp. 361-368 (1999 ).
Rangaswami, N. “ Wall jet analogy hydraulicjump ” Journal of Hydraulic Division , ASCE ,Vol.101 , No.HY3 , pp.347-359(1975).
Roberto, G. & Andrea, M. & Vittorio, B. “ Morphological effects of bed sills in degrading rivers ” Journal of Hydraulic Research , Vol.38 , No.2 , pp 89-95(2000 ).
Rouse, H. , Siao, T. T. & Nagaratnam, S. “Turbulence characteristics of the hydraulic jump” Journal of Hydraulic Engineering , ASCE , No.HY1 , pp1528-1-1528-30(1958) .