| 研究生: |
許毓樺 Yu-Hua Hsu |
|---|---|
| 論文名稱: |
氮化硼在(100)矽基板上的磊晶成長與特性分析 Growth and Characterization of Boron Nitride on Si(100) Substrates |
| 指導教授: |
賴昆佑
Kun-Yu Lai |
| 口試委員: | |
| 學位類別: |
碩士 Master |
| 系所名稱: |
理學院 - 光電科學與工程學系 Department of Optics and Photonics |
| 論文出版年: | 2025 |
| 畢業學年度: | 113 |
| 語文別: | 中文 |
| 論文頁數: | 50 |
| 中文關鍵詞: | 氮化硼 |
| 外文關鍵詞: | Boron Nitride |
| 相關次數: | 點閱:9 下載:0 |
| 分享至: |
| 查詢本校圖書館目錄 查詢臺灣博碩士論文知識加值系統 勘誤回報 |
本研究使用有機金屬化學氣相沉積法(Metal-Organic Chemical Vapor Deposition,
MOCVD),於高阻矽基板 Si(100) 上成長氮化硼(Boron Nitride, BN)薄膜,並探討不
同成長模式對其結構與電性表現之影響。成長模式主要分為連續氣流供應(Continuous
Flow, CF)與脈衝氣流供應(Pulsed Flow, PF),藉由控制氣體進入腔體的時序與流量,
調控BN薄膜在異質接面上的成核與堆疊機制。
結構分析方面,透過穿透式電子顯微鏡(TEM)、 X-ray 吸收光譜(XAS)與傅立葉轉換
紅外光譜(FTIR)等儀器,我們發現BN在 PF 模式下易形成亂層結構(turbostratic BN,
t-BN),而 CF 模式則傾向形成有序堆疊的六方結構 (hexagonal BN, h-BN)。t-BN與 Si
接面處具備較強的能帶偏折與界面重建能力,有利於二維電洞氣(2D Hole Gas, 2DHG)
的形成。根據低溫霍爾量測的結果,以PF成長的BN呈現較穩定的2DHG濃度及遷移
率,在 13K ~ 300K 的溫度範圍內,2DHG 的濃度及遷移率維持在 ~ 10¹⁵ cm⁻²、 ~50
cm²/V·s,並具備不隨溫度改變的遷移率,顯示其導電特性可能由介面載子累積層主導。
本研究結果證實,透過調控磊晶參數可有效誘發 BN/Si 異質結面之 2DHG 結構,對未
來發展高性能 P-channel 元件與氮化物異質整合技術具潛力,並提供後續磊晶製程與材
料工程之重要參考依據。
In this study, boron nitride (BN) thin films were grown on high-resistivity Si(100) substrates
using metal-organic chemical vapor deposition (MOCVD). The structural and electrical
properties of BN films under different growth conditions were systematically investigated.
Two precursor supply modes—continuous flow (CF) and pulsed flow (PF)—were compared,
with gas injection timing and flow rate modulation employed to control the nucleation and
stacking behavior of BN films at the heterointerface.
Structural analyses using transmission electron microscopy (TEM), X-ray absorption
spectroscopy (XAS), and Fourier-transform infrared spectroscopy (FTIR) confirmed that PF
growth tends to promote the formation of turbostratic BN (t-BN), while CF results in the
formation of well-ordered hexagonal BN (h-BN). The t-BN structure, particularly at the
BN/Si interface, exhibits significant band bending and interface reconstruction effects, which
are favorable for the formation of a two-dimensional hole gas (2DHG).
Further investigation via low-temperature Hall measurements revealed that PF-grown samples
exhibited high and thermally stable hole concentrations on the order of 10¹⁵ cm⁻².
Additionally, the hole mobility reached up to 51 cm²/V·s at room temperature and showed
minimal temperature dependence, suggesting that the transport characteristics are dominated
by an interface-accumulated carrier layer rather than thermally activated bulk conduction.
These results demonstrate that by precisely tuning the epitaxial growth parameters, it is
possible to effectively induce a 2DHG structure at the BN/Si heterointerface. This finding
provides a promising pathway for developing high-performance p-channel devices and
advancing heterointegration of BN-based materials, offering valuable guidance for future
epitaxy and materials engineering research.
[1] Olovsson, W., & Magnuson, M. (2022). Rhombohedral and turbostratic boron nitride
polytypes investigated by x-ray absorption spectroscopy. The Journal of Physical Chemistry
C, 126(49), 21101-21108.
[2] Chen, Y. H., Encomendero, J., Savant, C., Protasenko, V., Xing, H. G., & Jena, D. (2024).
Electron mobility enhancement by electric field engineering of AlN/GaN/AlN quantum-well
HEMTs on single-crystal AlN substrates. Applied Physics Letters, 124(15).
[3] Chaudhuri, R., Zhang, Z., Xing, H. G., & Jena, D. (2022). Very High Density (> 1014 cm−
2) Polarization‐Induced 2D Hole Gases Observed in Undoped Pseudomorphic InGaN/AlN
Heterostructures. Advanced Electronic Materials, 8(5), 2101120.
[4] Raj, A., Krishna, A., Hatui, N., Gupta, C., Jang, R., Keller, S., & Mishra, U. K. (2020).
Demonstration of a GaN/AlGaN superlattice-based p-channel FinFET with high ON-current.
IEEE Electron Device Letters, 41(2), 220-223.
[5] Chaudhuri, R., Bader, S. J., Chen, Z., Muller, D. A., Xing, H. G., & Jena, D. (2019). A
polarization-induced 2D hole gas in undoped gallium nitride quantum
wells. Science, 365(6460), 1454-1457.
[6] Bader, S. J., Chaudhuri, R., Nomoto, K., Hickman, A., Chen, Z., Then, H. W., ... & Jena,
D. (2018). Gate-recessed E-mode p-channel HFET with high on-current based on GaN/AlN
2D hole gas. IEEE Electron Device Letters, 39(12), 1848-1851.
[7] Chu, R., Cao, Y., Chen, M., Li, R., & Zehnder, D. (2016). An experimental demonstration
of GaN CMOS technology. IEEE Electron Device Letters, 37(3), 269-271.
[8] Reuters, B., Hahn, H., Pooth, A., Holländer, B., Breuer, U., Heuken, M., ... & Vescan, A.
(2014). Fabrication of p-channel heterostructure field effect transistors with polarization
induced two-dimensional hole gases at metal–polar GaN/AlInGaN interfaces. Journal of
Physics D: Applied Physics, 47(17), 175103.
[9] Hahn, H., Reuters, B., Pooth, A., Noculak, A., Kalisch, H., & Vescan, A. (2013). First
small-signal data of GaN-based p-channel heterostructure field effect transistors. Japanese
Journal of Applied Physics, 52(12R), 128001
[10] Nakajima, A., Sumida, Y., Dhyani, M. H., Kawai, H., & Narayanan, E. S. (2010). High
density two-dimensional hole gas induced by negative polarization at GaN/AlGaN
heterointerface. Applied physics express, 3(12), 121004.
[11] Shatalov, M., Simin, G., Zhang, J., Adivarahan, V., Koudymov, A., Pachipulusu, R., &
Khan, M. A. (2002). GaN/AlGaN p-channel inverted heterostructure JFET. IEEE Electron
Device Letters, 23(8), 452-454.
[12]https://labs.wsu.edu/mccloy/easyxafs300/#:~:text=EasyXAFS300+.%20The%20easyXAFS300+%20is%20a%20high%2Dpowered%20X%2Dray,synchrotron%20to%20be%20made
%20in%20the%20lab.