跳到主要內容

簡易檢索 / 詳目顯示

研究生: 張毅政
Yi-ChengChang
論文名稱: Pechan Prism應用於手持式顯微鏡
指導教授: 孫文信
Wen-Shing Sun
口試委員:
學位類別: 碩士
Master
系所名稱: 理學院 - 光電科學與工程學系
Department of Optics and Photonics
論文出版年: 2017
畢業學年度: 105
語文別: 中文
論文頁數: 75
中文關鍵詞: 稜鏡顯微鏡鏡頭設計
外文關鍵詞: Prism, Microscope, Lens design
相關次數: 點閱:21下載:0
分享至:
查詢本校圖書館目錄 查詢臺灣博碩士論文知識加值系統 勘誤回報
  • 本文論文提出手持式光學顯微鏡的鏡頭設計,共分為三個部分,分別為物鏡、稜鏡、目鏡的設計,設計完成之後在將這些設計組合在一起,達到顯微鏡的設計結果。物鏡的設計為10X放大率及NA為0.25,稜鏡的部分選用的是Pechan prism,目鏡的設計20X放大率,將物鏡、稜鏡、目鏡依循設計流程組合成200X放大率的顯微鏡,可以用來單獨使用於觀察物體。
    物鏡與稜鏡在設計上是同一個優化系統上完成的,藉由稜鏡的設計成功得將物鏡系統的長度由40.25 mm縮短至22.00 mm,其長度縮減幅度至45.34%。在最後顯微鏡設計組裝完成時,其系統總長度達到66.23 mm,符合手持式系統的要求,並且確認其系統影像品質判斷標準以Strehl ratio大於0.8來作為其評價需求。


    The design of portable microscope was introduced in this thesis. There are three parts in this design; an objective lens, a prism, and an eyepiece. Finally, combining objective lens, pechan prism and eyepiece to form an optical system.
    The objective lens’s magnification and NA are abbreviated as 10X/0.25. The selection of Prism is Pechan prism. The eyepiece magnification is 20X. By lens and prism combining, we can design a 200X microscope system. It can be operated individually to observe the object.
    The objective lens and the prism are built in the same optimization process. The length of objective system is reduced from 40.25 mm to 22.00 mm by the design of pechan prism. The length of the objective system is reduced by 45.34%. Finally, the total length of the microscope system is about 66.23 mm which achieves the purpose of being portable. In addition, Strehl ratio of an optical system is a diffraction limited system while the value is higher than 0.8.Therefore, the required microscope system’s Strehl ratio is higher than 0.8 to meet the image quality.

    中文摘要 I Abstract II 誌謝 III 目錄 IV 圖目錄 VI 表目錄 IX 第一章 緒論 1 1-1歷史回顧 1 1-2研究動機 2 1-3論文架構 2 第二章 基本原理 4 2-1光學顯微鏡的光學系統定義 4 2-1-1光學介電折射率的特性 4 2-1-2幾何光學中近軸近似的假設 5 2-1-3光學系統符號與其正負號定義 5 2-1-4三維方向角度的定義 5 2-2物鏡系統的原理 7 2-3目鏡系統的原理 9 2-4顯微鏡系統架構 12 2-5稜鏡的系統原理 14 第三章 光學顯微鏡之鏡頭設計 19 3-1物高設計規格 19 3-2系統波長的選定 20 3-3顯微鏡設定 21 3-4稜鏡的設定 22 3-5光學品質的評價 28 3-5-1 Strehl ratio 28 3-5-2光學畸變(Optical distortion) 29 3-5-3相對照度(Relative illumination) 29 3-6設計規格 29 第四章 光學設計方法 31 4-1物鏡設計 31 4-1-1物鏡初階設計結果 34 4-1-2稜鏡系統功能驗證 35 4-1-3物鏡光學品質檢驗 40 4-2目鏡設計 43 4-2-1目鏡初階設計規格 45 4-2-2目鏡光學品質檢驗 45 4-3顯微鏡設計 49 4-3-1顯微鏡初階設計規格 51 4-3-2顯微鏡光學品質檢驗 52 第五章 公差分析 56 第六章 結論 59 6-1研究成果 59 6-2未來展望 59 參考資料 61

    [1] M. W. Davidson, and M. Abramowitz, ”Optical microscopy, “Encyclopedia of imaging science and technology (2002).
    [2] S.F. Gibson, F. Lanni,” Experimental test of an analytical model of aberration in an oil-immersion objective lens used in three-dimensional light microscopy, “J. Opt. Soc. Am. A9, 154–166 (1992).
    [3] L. Schermelleh, R. Heintzmann, and H. Leonhardt, “A guide to super-resolution fluorescence microscopy, “ Journal of Cell Biology 190, 165-175 (2010).
    [4] S. Ram, E. S. Ward, and R. J. Ober, “A stochastic analysis of performance limits for optical microscopes, “ Multidimensional Systems and Signal Processing17, 27-57 (2006).
    [5] W. Denk, and H. Horstmann, “Serial Block-Face Scanning Electron Microscopy to Reconstruct Three-Dimensional Tissue Nanostructure, “PLOS Biology (November 2004, 2, e329): 1900-1909 (2004).
    [6] B. N. Giepmans, “Bridging fluorescence microscopy and electron microscopy, “Histochemistry and cell biology 130, 211-217 (2008).
    [7] G. Binnig, C. F. Quate, and C. Gerber, “Atomic Force Microscope, “ Physical Review Letters,56, 930-933 (1986)
    [8] C. C. Hsueh, and P. D. Lin, “Gradient matrix of optical path length for evaluating the effectsof design variable changes in a prism,” Appl. Phys. B: Lasers Opt. 98, 471–479 (2010).
    [9] Ivan Moreno, “Jones matrix for image-rotation prisms,”Appl. Opt. 43, 3373-3381 (2004).
    [10] C. Y. Tsai,andP. D. Lin “Prism design based on changes in image orientation,”Appl. Opt. 45, 3951-3959 (2006)
    [11] D. L. Sullivan, “Alignment of rotational prisms,”Appl. Opt. 11,2028–2032 (1972).
    [12] W. L. Wolfe, “Nondispersive prisms,” in Handbook of Optics,2nd ed., M.Bass, E. W. Van Stryland, D. R. Williams, andW. L. Wolfe, eds. (McGraw-Hill, New York), 4.1–4.29(1995).
    [13] 網路資料: Optical Glass 2016 - Catalogue - Schott AG
    http://www.schott.com/d/advanced_optics/c36214d9-13c4-468c-bf40-8d438b89f532/1.5/schott-optical-glass-pocket-catalog-february-2016-row.pdf
    [14] A. E. Attard, “Matrix Optical Analysis of Skew Rays in Mixed Systems of Spherical and Orthogonal Cylindrical Lenses,” Appl. Optics. 23, 2706-2709 (1984)
    [15] P.D. Lin, and C. H. Lu, “Analysis and Design of Optical System by Using Sensitivity Analysis of Skew Ray Tracing,” Appl. Opt. 43, 796-807 (2004).
    [16] V. N. Mahajan, Optical Imaging and Aberrations part I: ray geometrical optics, SPIE-The International Society for Optical Engineering (1998).
    [17] Synopsys, CODE V Electronic Document Library, Version 10.5, Lens System Setup for Reference Manuals, Chapter 8 Defining Tilts and Decenters (2012).
    [18] D. Malacaara, Z. Malacara, Handbook of Optical Design ,Second Edition., Marcel Dekker Inc, Chap.10 (2004).
    [19] 李正中,薄膜光學與鍍膜技術,藝軒圖書出版社,第六版。
    [20] M. Shaw, M. Fairchild, ”Evaluating the 1931 CIE Color Matching Functions,” Color Research and Application, 27, (2002).
    [21] S. Bradbury and B. Bracegirdle , Introduction to Light Microscopy, BIOS Scientific Publishers Ltd., Oxford, UK (1998).
    [22] B. Bracegirdle, ”The performance of seventeenth and eighteenth century microscopes, “ Medical History.22, 187–195(1978)
    [23] L. N. Andreev, “Creation of an optical element base for microscopes, “ Journal of Optical Technology67, 368-370 (2000).
    [24] W. J. Smith, “ Modern Optical Engineering,”3rd ed. (Edmund Industrial Optics), 100–121 (2001)
    [25] 網路資料: Optical Prism Application Examples
    https://www.edmundoptics.com/resources/application-notes/optics/optical-prism-application-examples/

    QR CODE
    :::