近年來土木工程建設損傷評估漸漸受到工程人員的重視。在本研究中，我們應用摸態分析技術來針對人工缺陷梁進行檢測。另外我們必須發整一套量測技術以獲得足夠的分析資料。我們使用Graffi’s彈性動力互易定理，由最少數量的感測計獲的梁之振動反應。藉由傳遞函數法及亞伯拉罕時間序列法，從所得之離散振動訊號來求得有/無損傷梁之模態。
我們可以由傳遞函數及亞伯拉罕時間序列法所獲得之模態振動函數，求得鋁梁之缺陷位置。由於亞伯拉罕時間序列法是採用穩態振動訊號，而傳遞函數法是使用暫態反應，因此並不會受到外加作用力延遲的影響。在研究中，使用亞伯拉罕時間序列法來進行損傷檢測，似乎比較容易也比較穩定。我們也對雙裂縫梁進行損傷評估，發現獲得一趨勢，但結果沒有比單一裂縫來得顯著。在現今的研究中，一套簡單的梁損傷評估量測分析技術已逐漸發展。而這門技術可以延伸至複雜的構架系統。

Damage assessment of civil infrastructure is interested by engineers for decades. In this study, the modal analysis technique is applied to detect artificial defects of beams. To get enough analysis data, a measurement technique is also developed. The Graffi’s dynamic reciprocal theory of elasticity is used to obtain vibration response at impact sites along the beam from a minimum number of sensors. Mode shapes of undamaged and damaged beams by the transfer function method and Ibrahim time domain (ITD) method can be calculated from these distributed vibration signals.
Location of defects in the aluminum beam can be detected from the variation of mode shape function either from the ITD or the transfer function method. Since the ITD technique just is using the vibration signals of steady state and does not like the transfer function technique uses the transient response that is affected by the duration and intensity of input loading. It seems that the damage mode obtained by ITD method is more stable and is easier for damage detection. Damage assessment of a beam with two separated cracks was also conducted, the locations of defects can be detected but was not so distinguished as the case of single defect. However, a simple measurement and analysis technique for damage assessment of beam is developed in current study. This technique can be extended to complicated frame structure.

參考文獻
1. Lew, Jiann-Shiun “Using Transfer Function Parameter Change for Damage Detection of Structure,”AIAA，Vol.33，No.11，pp.2189-2193（1995）.
2. 康裕明、徐耀賜，「以落體測位儀評估橋樑動態反應的可行性研究」，海峽兩岸橋樑工程學術與實務研討會論文集，第263-273頁（1995）.
3. Kahal, K., “Damage Detection in Beam Structures Using Subspace Rotation Algorithm with Strain Data,” AIAA, JOURNAL, Vol. 34, No. 12, pp. 2609-2614（1996）.
4. 曾世雄、林明昭，「缺陷能在整體性破壞檢驗的應用」 ，第三屆結構工程研討會論文集，第1457-1466頁（1996）.
5. 曾世雄、林明昭，「以缺陷能法進行整體性非破壞檢測」，中國土木水利工程學刊， 第十卷，第二期，第389-396頁（1998）.
6. Stubbs, Norris and Kim, Jeong-Tae, “Damage Localization in Structures Without Baseline Modal Parameters” , AIAA, Vol. 34, No. 8, pp. 1644-1649（1996）.
7. Yang, X. F., Swamidas A. S. J. and Seshadri R., “ Crack Identification in Vibration Beams Using The Energy Method, ” Journal of Sound and Vibration ,Vol. 244, No. 2, pp. 339-357（2001）.
8. Zang, C., “ Structural Detection Using Artifical Nerual Networks and Measured FRF Data Reducde VIA Principal Compoment Projection, ” Journal of Sound and Vibration ,Vol. 242, No. 5, pp. 813-827（2001）.
9. 王柏村、梁偉光 ,「基於模態參數之結構缺陷預測」，檢測科技，第十八卷，第六期，第204-214頁（2000）.
10. Palacz, M. , “ Vibration Parameters For Damage Detection Structures, ”Journal of Sound and Vibration ,Vol. 249, No. 5, pp. 999-1010（2002）.
11. Gongkang, Fu, “Signal Versus Noise in Damage Detection by Experimental Modal Analysis,” Journal of Structural Eengineering, pp. 237-245（1997）.
12. Zhao, Jun and John T. DeWolf, “Sensitivity Study For Vibrational Parameters Used In Damage Detection,” Journal of Structural Eengineering, pp. 410-416（1999）.
13. Hoyos, A. and Aktan A. E., “Regional identification of engineered structures based on impact induced transient responses,” Res. Rep. No. 87-1, Louisiana State University（1987）.
14. Harry, W. Shenton Ⅲ, “ Damage Detection in Beams on Redistribution of Dead Load, ” Health Monitoring and Management of Civi Infrastructure System, Vol. 4337, pp. 105-112（2001）.
15. 倪勝火、羅國峯,「小波轉換法應用於基樁音波回應法之分析研究」，檢測科技，第十九卷，第一期，第4-15頁（2001）.
16. 林其璋、黃群堯、王傑兒,「鋼筋混凝土樑損壞之識別」,結構工程，第十三卷，第四期,第19-39頁（1998）.
17. 吳開慶,「應用地震反應記錄之扭轉耦合結構參數識別」,國立中興大學土木工程研究所碩士論文（1996）.
18. Ibragim, S. R., “Double Least Squares Approach for Use in Structural Modal Identification,” Journal of Spacecraft and Rockers, AIAA, pp. 499-503（1986）.
19. Lim, Tae W., Albert Bosse and Shalom Fisher, “Structural Damage Detection Using Real-Time Modal Parameter Identification Algorithm,” AIAA, Vol. 34, No. 11, pp. 2370-2376（1996）.
20. 連祥益，「動力互易定理於梁損傷檢測之應用」，國立中央大學土木工程學系碩士論文（2001）.
21. Pei-Ling Liu, Cheng-Chieh Chen, “Parameter Identication of Frame Structures using Transient Strains,” The Chinese Journal of Mechanics,Vol. 16, No. 4, pp. 217-225（2000）.
22. Yule, G. U.,”On a Method of Investigating Periodicity in Disturbed Series” Special Reference to Wotfers Spot Numbers, Philo. , A226,
267（1927）