跳到主要內容

簡易檢索 / 詳目顯示

研究生: 李昆築
Kun-Chu Lee
論文名稱: 應用於都卜勒超音波系統之 轉導放大器積體電路設計
An Integrated Operational Transconductance Amplifier Design for Doppler Ultrasound System
指導教授: 夏勤
Chin Hsia
口試委員:
學位類別: 碩士
Master
系所名稱: 資訊電機學院 - 電機工程學系
Department of Electrical Engineering
論文出版年: 2018
畢業學年度: 106
語文別: 中文
論文頁數: 63
中文關鍵詞: 都卜勒超音波轉導放大器積體電路
外文關鍵詞: Doppler Ultrasound, Operational Transconductance Amplifier, Integrated Circuit
相關次數: 點閱:12下載:0
分享至:
查詢本校圖書館目錄 查詢臺灣博碩士論文知識加值系統 勘誤回報
  • 近年全球高齡化帶動整個治療及輔助醫療器材市場發展,特別是居家照護使用,如血糖儀、血壓計等,因此發展移動性、微型化與低功率消耗之照護設備是非常重要。
    本論文提出用於血流速度感測之都卜勒超音波系統中探頭的驅動電路設計,為高電流、高線性度與低功率消耗之轉導放大器。提出三種電路架構討論,分別為傳統型二級放大器、互補式雙級放大器與具迴轉率補償之驅動電路。論文所提出之架構以積體電路設計並實現,透過VIS 0.5µm SOI 2P4M POLYCIDE 5V CMOS製程使用,供應電壓為5V,負載為超音波探頭等效電容2nF。互補式雙級放大器面積為850*560µm2,具迴轉率補償之驅動電路面積為812.5*532.07µm2,晶片量測分別達到5MHz正弦波訊號與10MHz正弦波訊號操作,slew-rate分別達到68V/µs與100V/µs,靜態功率消耗分別為140mW與48mW。
    對於超音波探頭之大電容性負載,使用論文提出之電路架構驅動,可以使整體系統功率消耗降低。發展電池使用之微型化、穿戴式或移動性醫療產品能夠延長使用週期,使產品的穩定性大幅地提升。


    In recent years, the global aging has driven the development of the therapeutic and auxiliary medical device market, especially the use of home care, such as blood glucose meters, blood pressure monitors, etc. Therefore, it is very important to develop care equipment with mobility, miniaturization, and low power consumption.
    This paper presents the design of the probe driving circuit in Doppler ultrasound system for blood flow sensing, which is an operational- transconductance-amplifier(OTA) with high current, high linearity, and low power consumption. Three circuit architectures are presented, namely conventional OTA architecture, complementary OTA architecture, and OTA with slew rate enhancer. The circuits in this paper are designed and implemented with an integrated circuit. They were fabricated in VIS 0.5μm SOI 2P4M 5V CMOS process. The supply voltage is 5V, and the load capacitor is 2nF. The area of complementary OTA architecture is 850*560µm2. The area of OTA with slew rate enhancer is 812.5*532.07μm2. The IC measurement achieves 5MHz sine wave signal and 10MHz sine wave signal, respectively. The slew-rate is 68V/μs and 100V/μs, and the static power consumption is 140mW and 48mW, respectively.
    For the large capacitive load of ultrasound probes, using the architectures proposed in this paper to drive can reduce the overall system power consumption. The development of miniaturized, wearable or mobile medical products for battery-powered can extend the life cycle, and the stability can be greatly improved.

    摘要 i Abstract ii 誌謝 iii 目錄 iv 圖目錄 vi 表目錄 ix 一、 緒論 1 1.1. 研究背景 1 1.2. 研究動機與目的 2 1.3. 章節介紹 2 二、 原理與介紹 4 2.1. 超音波探頭 4 2.1.1. 都卜勒效應 4 2.1.2. 工作原理 5 2.2. 系統架構 7 三、 電路設計與模擬 9 3.1. Conventional OTA architecture 9 3.2. Proposed OTA architecture (ver.1) 11 3.2.1. 電路架構(Complementary OTA circuit) 11 3.2.2. 迴轉率(Slew rate) 11 3.2.3. 偏置電流電路(Bias circuit) 14 3.2.4. 模擬結果(Post-layout simulation) 16 3.3. Proposed OTA architecture (ver.2) 19 3.3.1. 電路架構(OTA with slew rate enhancer) 19 3.3.2. 模擬結果(Post-layout simulation) 22 四、 電路量測與實驗 27 4.1. 晶片量測(Complementary OTA circuit) 27 4.1.1. 直流訊號量測 28 4.1.2. 暫態訊號量測 29 4.2. 晶片量測(OTA with slew rate enhancer) 32 4.2.1. 直流訊號量測 32 4.2.2. 交流訊號量測 33 4.2.3. 暫態訊號量測 35 4.3. 超音波探頭訊號強度實驗 41 五、 結論與未來展望 49 參考文獻 51  

    [1] CNNMoney : the 'super-aged' nation. 取自http://money.cnn.com/interactive/news/aging-countries/?iid=EL。
    [2] 凱基投信:全球醫材商機,比你想的還要大。2017年4月5日,取自https://www. kgifund.com.tw/edm_rwd/20170405.html。
    [3] John M. Reid, “Doppler Ultrasound,” IEEE Engineering in Medicine and Biology Magazine, Vol. 6, no. 4, pp.14-17, Dec. 1987.
    [4] 詠業科技:壓電技術介紹。取自https://www.unictron.com/%E6%8A%80%E8%A1% 93%E8%B3%87%E6%96%99/%E5%A3%93%E9%9B%BB%E6%8A%80%E8%A1%93%E4%BB%8B%E7%B4%B9/。
    [5] 白富升,黃慶連,林家宏,薛儒鴻,「壓電陶瓷共振系統之設計與實現」,中華民國第三十一屆電力工程研討會,2160-2164頁,台南市,中華民國,2010年12月。
    [6] K.-C. Lee, and C. Hsia, “Design of Combined PWM/PFM Controlled Boost Converter for Pulsed Doppler Ultrasound Transmitters,” 2018 IEEE International Conference on Consumer Electronics-Taiwan (ICCE-TW), pp. 315-316, Taichung, Taiwan, May 2018.
    [7] K.-C. Lee, and C. Hsia, “An Integrated High-slew-rate Low Power OTA Design for Doppler Ultrasound Transmitters,” 2017 IEEE International Conference on Consumer Electronics-Taiwan (ICCE-TW), pp. 29-30, Taipei, Taiwan, June 2017.
    [8] Behzad Razavi, 類比CMOS積體電路設計,李泰成譯,修訂版,東華書局,台北市,民國103年。
    [9] Paul R. Gray, Paul J. Hurst, Stephen H. Lewis and Robert G. Meyer, ANALYSIS AND DESIGN OF ANALOG INTEGRATED CIRCUITS, Fifth edition, John Wiley & Sons, Inc., United States of America, 2009.
    [10] 羅姆半導體:迴轉率介紹說明。取自https://www.rohm.com.tw/electronics-basics /opamps/op_what5。
    [11] C.-W. Lu, and C.-L. Lee, “A low power high speed class-AB buffer amplifier for flat panel display application,” IEEE Transactions on Very Large Scale Integration (VLSI) Systems, vol. 10, no. 2, pp. 163-168, Apr. 2002.
    [12] H.-b. Le, X.-d. Do and S.-g. Lee, “Compact low-power high-slew-rate buffer for LCD driver applications,” IET Electronics Letters, Vol. 46, no. 20, pp.1370-1371, Sep. 2010.
    [13] Mohammad Amayreh, Joachim Leicht, and Yiannos Manoli, “A 200ns settling time fully integrated low power LDO regulator with comparators as transient enhancement,” 2016 IEEE International Symposium on Circuits and Systems (ISCAS), pp. 494-497, Montreal, Canada, May 2016.
    [14] J. Pérez-Bailón, A. Márquez, B. Calvo, N. Medrano, and P.A. Martínez, “Fast-transient high-performance 0.18 μm CMOS LDO for battery-powered systems,” IET Electronics Letters, Vol. 53, no 8, pp.551-552, Apr. 2017.
    [15] P.-J. Liu, J.-S. Hong, and J.-M. Wang, “A fast-transient buffer with voltage booting technique for LCD column drivers,” 2014 International Conference on Information Science, Electronics and Electrical Engineering, pp.535-539, Sapporo, Japan, Apr. 2014.

    QR CODE
    :::