跳到主要內容

簡易檢索 / 詳目顯示

研究生: 黃柏淙
Bo-Tsung Huang
論文名稱: 微創手術機械手臂之動態模擬與分析
Dynamics Simulation and Analysis in the Endo Wrist of Minimally Invasive Surgery(MIS)
指導教授: 張江南
Chiang-Nan Chang
口試委員:
學位類別: 碩士
Master
系所名稱: 工學院 - 機械工程學系
Department of Mechanical Engineering
畢業學年度: 94
語文別: 中文
論文頁數: 59
中文關鍵詞: 微創手術機椷臂感測器動態模擬與分析
外文關鍵詞: Endo wirst in MIS, Sensors, Dynamics simulation
相關次數: 點閱:8下載:0
分享至:
查詢本校圖書館目錄 查詢臺灣博碩士論文知識加值系統 勘誤回報
  • 微創手術已儼然漸漸成為目前許多重要手術的主流,但目前所面臨的其中一個問題為---當醫生藉由3-D影像來操控機械臂的時候,並沒有辨法像傳統手術一樣去感受其力道大小。
    本論文主要研究內容為微創手術機椷臂在執行手術時的一些動態行為與探討其受力情形。使用之軟體為Unigraphics、Matlab、MSC Visual NASTRAN 4D等三套。在分析過程由於必須精準地知道機械臂的位置與馬達的轉角,所以預先採用了順向及逆向運動學來推導整個機械臂的動態平衡方程式。先以Unigraphics建立模型,再以Matlab做數值運算,最後載入MSC Visual NASTRAN 4D 做動態模擬與分析。
    模擬的部分包括機械臂夾針頭、針頭在兩個機械臂間的傳遞,最後進一步地分析夾針頭時的動態受力情形來探討此機械臂是否有改善的空間;此外,如果能在機械臂加上一個感測器,讓感測器可以用來做為力回饋的依據,將其數據表現在3-D螢幕地兩旁更可以有效改善醫生手術時的效率。


    Minimally invasive surgery (MIS) is becoming the mainstream of some important surgeries. One problem that bothers the surgeon is that when he manipulates the endo wrist by seeing the 3-D imagine, he can not sense the force feedback just as the traditional surgery.
    The research contents of the thesis focus on the kinematic behavior and the distribution of the loading in the minimally invasive surgery. The softwares such as Unigraphics、Matlab、MSC Visual NASTRAN 4D were uesd for dynamic simulation. Before analyzing, precise postion of the wrist and the angle of the motors must be previously known. The equilibrium equation of motion was derived by using the forward and inverse kinematics in advance. First of all, I used the Matlab to apply numerical analysis, the second, I built up the model by using Unigraphics, finally, I put them to the MSC to simulate the kinematics.
    The simulation included the wrist clamp the needle、the needle was delivered between the two wrist and some distributions of kinematic loading when wrist clamped the needle. According to the result the possibility of installing a sensor on the wrist were discussed. The sensor could be the basement of the force feedback, if the data of the sensor could be use to display on the 3D monitor, I think it would improve the efficiency when surgeon operates the surgery.

    摘要 ……………………………………………………………………Ⅰ Abstract ………………………………………………………………..Ⅱ 誌謝 ……………………………………………………………………Ⅳ 目次 ……………………………………………………………………Ⅴ 圖目錄 …………………………………………………………………Ⅶ 表目錄…………………………………………………………………ⅩⅡ 第一章 緒論 …………………………………………………………1 1.1 前言 …………………………………………………………1 1.2 研究動機與目的 ……………………………………………2 1.3 本文架構 ……………………………………………………3 第二章 機械臂之模型架構及運動學推導………………………4 2.1機械臂之模型假設與定義……………………………………4 2.2 順向運動學 …………………………………………………5 2.3 逆向運動學 …………………………………………………9 2.4 Newton-Euler動態方程式………………………………..12 第三章 機械手臂動態模擬與分析………………………………17 3.1 模型建立………………………………...………………….17 3.2 機械臂夾針頭…..……………………………………..……20 3.3 針頭在兩個機械臂間的傳遞…………...………….………25 3.3.1 Part I 機械臂均為不動…………………………25 3.3.2 Part II 機械臂為動態…………………………..36 第四章 機械手臂動態模擬受力分怖………...…………………45 4.1 Part I 作用點為一點時:………………….……….46 4.2 Part II 受力點為三個方向的反作用力………….…49 4.3 Part III 尾端針頭受力分析………………..………52 4.4 結果與討論……………………………………………54 第五章 結論與未來展望 ……………………………………………..55 參考文獻 ………………………………………………………………56

    [1] Yang Zehong, Jia Peifa, Zhao Yannan, Yang kandong, “A Force Feedback System based on Robot Control,” Proceedings of the 4’ World Congress on Intelligent Control and Automation, Shanghai, P.R.China, pp. 2860-2864, June 10-14, 2002.
    [2] Jinung An, Dong-Soo Kwon, “Haptic Experimentation on a Hybrid Active/Passive Force Feedback Device,” Proceedings of the 2002 IEEE International Conference on Robotics 8 Automation, Washington DC, pp. 4217-4222, May, 2002.
    [3] M. Tavakoli, R.V. Pat.el and M. Moallem, “A Force Reflective Master-Slave System for Minimally Invasive Surgery,” Proceedings of the 2003 IEEElRSlIntl. Conference on Intelligent Robots and Systems Las Vegas. Nevada, pp. 3077-3082, '' October 2003
    [4] Elane Chen and Beth Marcus, “Force Feedback for Surgical Simulation,” Proceedings of the IEEE, VOL. 86, NO. 3, pp. 524-530, March 1998
    [5] Katherine J. Kuchenbecker, William R. Provancher,_Gunter Niemeyer, Mark R. Cutkosky_“Haptic Display of Contact Location,” Proceedings of the 12th International Symposium on Haptic Interfaces fo8r Virtual Environment and Teleoperator Systems, 2004
    [6] Tatsuya Koyama, Ikuo Yamano, Kenjiro Takemura, Takashi Maeno, “Multi-Fingered Exoskeleton Haptic Device using Passive Froce Feedback for Dexterous Teleopertion,” proceedings of the 2002 IEEE/RSJ lntl. Conference on Intelligent Robots and Systems EPFL, Lausannne,Switzerland, pp. 2905-2910,October 2002.
    [7] Cornelis A. Grimbergen, Joris E.N. Jaspers, “Robotics in minimally invasive surgery,” IEEE International Conference on Systems, Man and Cybernetics, pp. 2486-2491, 2004
    [8] Nicolas Cauche, Alain Delchambre'', Patrice Rouille, Patrick Helmer, Charles Baur, Reymond Clavel, “Rotational Force-feedback Wrist,” hoceediags ofthe sm IEEE International Symposium on Assembly and Task Planning Besanqon, France, pp. 205-210, July 10-11,2003
    [9] Munehisa KUSANO, Kazuaki TANAKA, Norihiro ABE, “Synchronized processing of Tele-manipulation system,” Proceedings of the Seventh International Conference on Virtual Systems and Multimedia, 2001
    [10] Wagahta Semere, Masaya Kitagawa and Allison M. Okamura,
    “Teleoperation with Sensor/Actuator Asymmetry:Task Performance with Partial Force Feedback,” Proceedings of the 12th International Symposium on Haptic Interfaces for Virtual Environment and Teleoperator Systems (HAPTICS’04), 2004
    [11] Peter J. Berkelman, Louis L. Whitcomb, Russell H. Taylor, and
    Patrick Jensen, “A Miniature Microsurgical Instrument Tip Force
    Sensor for Enhanced Force Feedback During Robot-Assisted Manipulation,” IEEE TRANSACTIONS ON ROBOTICS AND AUTOMATION, VOL. 19, NO. 5, PP. 917-922, OCTOBER 2003
    [12] A. Wr6blewska, “Methods of the force measurement for robotic surgical tools,” Fifth International Workshop on Robot Motion and Control,pp.51-54, June 23-25, 2005
    [13] Shuxin Wang, Jienan Ding, Jintian Yun and Qunzhi Li Baoping Han, “A Robotic System with Force Feedback for Micro-Surgery,"Proceedings of the 2005 IEEE International Conference on Robotics and Automation Barcelona, pp. 199-204 Spain, April 2005
    [14] S. Greenish, V. Hayward, V. Chial, A. Okamura, T. Steffen "Measurement, analysis,and display of haptic signals during surgical cutting." Presence: volume 11, number 6 December 2002, 626-651.
    [15] A. Menciass, A. Eisinberg, C. Carrozza, M. and P. Dario "Force Sensing Micro instrument for Measuring Tissue Properties and Pulse in Microsurgery" 1EEE/ASME TRANSACTIONS
    on MECHATRONICS, VOL. 8, so. 1, MARCH 2003
    [16] C.R. Wagner, N. Stylopoulos, R.D. Howe "The Parts Of Force Feedback In Surgery: Analysis Of Blunt Dissection." Presented at the Tenth Symposium on Haptic Interfaces for Virtual Environment and the Systems Teleoperator, March 24-25, 2002, Orlando
    [17] "Force-reflecting surgical tool and positioning mechanism for performing minimally invasive surgery with enhanced dexterity and sensitivity U.S. Documents patent sep. 15, 1998
    [18] Peirs Jan, Joeri Clijnen, Dominiek Reynaerts, Hendrik Van Brussel, Herijgers Paul, Corteville Brecht, Sarah Boone "A micro optical force sensor for force feedback during minimally invasive robotic surgery." Sensors and Actuators and 115 (2004) 447-455 www.sciencedirect.com 27 July 2004
    [19] A. Krupa, G. Morel, M. de Mathelin "Achieving High Precision Laparoscopic Manipulation Through Adaptive Force Control." IEEE ICRA lnternational Conference of Robotics and Automation, May 1 1-15, 2002 D.C Washington
    [20] T. Ortmaier, M. Groeger, U. Seibold, U. Hagn, D. Boehm, H. Reichenspurner, G. Hirzinger "Autonomy and Haptic Feedback in Minimally lnvasive Robotic Surgery." Presented at the Fourth
    Annual Scientific Meeting of the International Society for Minimally Invasive Cardiac Surgery, June 27-30, 2001, Munich, Germany.
    [21] 吳駖,MATLAB 6.X與基礎自動控制,文魁資訊股份有限公司,2002
    [22] William J. P.著,呂明和等譯,MATLAB 6在工程上的應用-MATLAB 6.5 Update,美商麥格羅.希爾國際股份有限公司,臺北分公司,2003
    [23] 張智星,MATLAB程式設計與應用,清蔚科技股份有限公司出版事業部,2000
    [24] 黃錦煌等,機構模擬,全華科技圖書股份有限公司,2002
    [25] 楊智旭,張嘉峰,楊政達,MATLAB進階與工程問題應用,全威圖書有限公司,2003
    [26] 黃俊明、吳運明、詹永裕,Unigraphics 模型設計 知城數位科技股份有限公司,2002

    QR CODE
    :::