| 研究生: |
謝延浩 Yen-hao Hsieh |
|---|---|
| 論文名稱: |
非標準箍筋配置之低強度混凝土柱耐震行為探討 Experimental study on reinforced concrete columns with low-strength concrete and substandard transverse hoops |
| 指導教授: |
王勇智
Yung-chih Wang |
| 口試委員: | |
| 學位類別: |
碩士 Master |
| 系所名稱: |
工學院 - 土木工程學系 Department of Civil Engineering |
| 畢業學年度: | 99 |
| 語文別: | 中文 |
| 論文頁數: | 132 |
| 中文關鍵詞: | 耐震行為 、剪力 、鋼筋混凝土柱 、低強度混凝土 、箍筋 、塑性鉸 |
| 外文關鍵詞: | plastic hinge, low-strength concrete, RC column, shear, seismic resistance hoops |
| 相關次數: | 點閱:7 下載:0 |
| 分享至: |
| 查詢本校圖書館目錄 查詢臺灣博碩士論文知識加值系統 勘誤回報 |
本實驗共製作四支柱試體,實驗試體包含一根符合現行規範配筋之柱試體,而其他三根為有缺失之柱試體,其缺失為低強度混凝土、箍筋形式與箍筋間距。四根試體主要模擬低矮樓房之耐震行為,藉此觀察RC柱受側向力作用時的強度、韌性發展、裂縫的發展情形、與破壞形式。
由實驗結果顯示,根據規範相關規定施做設計的試體,於塑鉸區有緊密箍筋圍束,能有效仰制柱底剪力變形,以致於有良好韌性發展。對於設置箍筋形式與箍筋間距缺失之柱試體,由於會產生柱底剪力破壞。而使用低強度混凝土之柱試體,混凝土無法提供主筋有效握裹,所以最後產生主筋握裹破壞行為。
Four RC columns were tested in the study. One of columns was designed to a ductile behavior specified with ACI code provision. Others were non-ductile columns which simulated their substandard design in concrete strength and transverse hoops. The purpose of this study is to observe the seismic behaviors of test units.
From the test results, the standard specimen, having close transverse reinforcement inside the column, performed a ductile behavior. For the specimens with poor hoop configuration and lose tie spacing, they failed in a brittle manner. The strength decreased rapidly and shear failure was observed in the column hinge zone. For RC columns with low-strength concrete, the bond failure mode of longitudinal reinforcement occur because such low concrete strength can not provide sufficient bond strength for longitudinal reinforcement.
[1]詹氏書局,建築技術規則,詹氏書局,台北市,民國六十三年。
[2]詹氏書局,最新建築技術規則,詹氏書局,台北市,民國七十二年。
[3]中國土木水利工程學會,混凝土工程設計規範與解說,初版,科技圖書,台北市,民國九十六年。
[4]中國土木水利工程學會,鋼筋混凝土建築設計規範(土木 401 - 68),初版,科技圖書,台北市,民國六十八年。
[5]E.N.B.S. Júlio, F.A.B. Branco, and V.D. Silva, “Reinforced Concrete Jacketing—Interface Influence on Monotonic Loading Response,” ACI Structural Journal, V. 102, No. 2, pp.252-257, March-April 2005.
[6]K. G. Vandoros and S. E. Dritsos, “Axial preloading effects when reinforced concrete columns are strengthened by concrete jackets,” Struct Engng Mater, Vol.8, pp.79-92, July 2006.
[7]K. G. Vandoros and S. E. Dritsos, “Concrete jacket construction detail effectiveness when strengthening RC columns,” Construction and Building Materials, Vol. 22, pp. 264-276, 2008.
[8]E.N.B.S. Júlio, F.A.B. Branco, and V.D. Silva, “Reinforced Concrete Jacketing—Interface Influence on Cyclic Loading Response,” ACI Structural Journal, V. 105, No. 4, pp.471-477, July-August 2008.
[9]L. Bedirhanoglu , A. Ilki , S. Pujol and N. Kumbasar, “ Behavior of Deficient Joints with Plain Bars and Low-Strength Concrete,” ACI Structural Journal, V. 107, No. 3, pp.300-310, May-June 2010.
[10]ACI Committee 318, Building Code Requirements for Reinforced Concrete(ACI318-71), American Concrete Institute, 1971.
[11]江振堂,「不同箍筋型式對低強度與普通強度混凝土柱圍束效應之研究」,國立中央大學,碩士論文,民國一百年。
[12]蔡攀鰲,土木材料試驗,三民書局,台北市,183-188頁,民國七十五年。
[13]湯兆緯、陳冠宏、張朝順,土木材料,高立圖書有限公司,台北縣,184-185頁,民國九十四年。