| 研究生: |
陳思儒 Szu-Ju Chen |
|---|---|
| 論文名稱: |
使用發泡瀝青之冷拌再生瀝青混凝土強度發展初步探討 The Preliminary Study of the Strength and Age of Cold Recycled Asphalt Concrete Using Foam Asphalt |
| 指導教授: |
陳世晃
Shih-Huang Chen |
| 口試委員: | |
| 學位類別: |
碩士 Master |
| 系所名稱: |
工學院 - 土木工程學系 Department of Civil Engineering |
| 論文出版年: | 2020 |
| 畢業學年度: | 108 |
| 語文別: | 中文 |
| 論文頁數: | 121 |
| 中文關鍵詞: | 冷拌再生瀝青混凝土 、強度 、發泡瀝青 |
| 外文關鍵詞: | Cold recycled concrete, Strength, Foamed asphalt |
| 相關次數: | 點閱:13 下載:0 |
| 分享至: |
| 查詢本校圖書館目錄 查詢臺灣博碩士論文知識加值系統 勘誤回報 |
冷拌再生瀝青混凝土鋪面相較於其他材料而言,更有明顯齡期強度發展趨勢,對該材料強度發展與時間關聯性之探討有其必要性,有助於該材料使用於鋪面工程上之品質控制;以國內外應用而言,水泥常用於增加冷拌再生瀝青混凝土之抗剝脫能力及固化作用,且水泥之固化作用對於冷拌再生養治時間具顯著影響。本研究目的為研究使用發泡瀝青之冷拌再生瀝青混凝土強度發展趨勢線,本研究所採用之材料為傳統級配粒料及使用發泡瀝青之冷拌再生瀝青混凝土(以下簡稱冷拌發泡再生),傳統級配粒料為對照組,冷拌發泡再生為實驗組;首先於實驗室內進行相關材料試驗以及配合設計,並以配合設計結果進行現地試鋪,完成後即使用多種儀器量測不同齡期之強度發展,由強度發展曲線得知冷拌再生瀝青混凝土之強度發展明顯優於傳統級配粒料,且冷拌再生發泡瀝青混凝土於初期養治8小時快速發展強度,並於中後期24小時後趨於平緩,而級配粒料則無明顯發展趨勢,其原因應為發泡瀝青穩定處理及水泥水化作用,於鋪面壓實完成後齡期初期即有強度發展,相對於傳統級配而言,冷拌再生瀝青混凝土確實有較高之強度,冷拌發泡再生之回彈模數與齡期關係為y=4.24ln(x)+24.13,其R2高達0.9;為確保該材料之強度,本研究建議新建工程使用本材料養治時間為24小時,養護工程則為4小時;現地驗證以新北市冷拌再生發泡瀝青試驗道路測試本研究建議之養護時間是否合適,該道路於養治時間1小時15分即可符合本研究強度發展曲線之建議強度要求,綜合以上各點所述,冷拌再生發泡瀝青應用在鋪面工程上確實有其優點與競爭力,非常值得進一步研究與應用。
Compared with other materials, cold-mixed recycled asphalt concrete pavement has more obvious development trend of aging strength that is necessary to discuss the relationship between the strength and curing time, which is helpful for the use of the material in pavement. In terms of domestic and foreign applications, cement can increase the anti-stripping ability and enhance the solidification, which make the curing time have discrepancy. The study uses Light Weight Deflectometer and Clegg Impact Soil Tester to determine the ELWD and Clegg Impact Value (CIV), in the light of studying the age strength of development of the cold mix recycling asphalt concrete to confirm the material properties. The strength of cold mix recycling asphalt concrete has a rapid development in the initial curing time, and gradually leveling off in the late period. However, the aggregate gradation has no obvious development. According to the strength development curve module, the regeneration between the ELWD and aging time is y=4.24ln(x)+24.13, and R2 is 0.9; To ensure the strength of the material, this study recommends the use of this material for the new construction project, the curing time is 24 hours, and the maintenance project is 4 hours. The test road in New Taipei City can meet the recommended strength requirements of the strength development curve of this study within 1 hour and 15 minutes of curing time. Based on the above points, the application of cold-mixed recycled foamed asphalt in pavement engineering does have its advantages and competitiveness, and it is well worth it in Further research and application.
中華民國交通部統計查詢網,http://stat.motc.gov.tw/mocdb/stmain.jsp?sys=
210&funid=b340101&type=1
行政院公共工程委員會,施工綱要規範第02714章,V2.0「瀝青處理底層」。
行政院公共工程委員會,施工綱要規範第02726章,V10.0「級配粒料底層」。
行政院公共工程委員會,施工綱要規範第02742章,V10.0「瀝青混凝土鋪面」。
內政部營建署,(2019),冷拌再生瀝青混凝土規範暫行版
維特根,(2004),「冷再生技術手冊」,第二版,德國。
呂柏璋,(2012),「溫拌瀝青混凝土應用於台灣地區可行性研究」,國立中央大學土木工程學系碩士論文,桃園。
杜嘉崇、陳朝雯、陳光耀,(2013),「綠道路之鋪面刨除料於基底層改良」,行政院國家科學委員會專題研究計畫期末報告,新北。
杜嘉崇、蕭炎泉、李東林,(2005),「乳化瀝青常溫拌合特性之研究」,臺灣公路工程,第三十一卷,第十二期,第18-25頁。
杜嘉崇、葉榮晟、李艾倫,(2013),「刨除料應用於排水瀝青混凝土之研究」,鋪面工程,第十一卷,第一期,第67-72頁。
林奕君,(2016),「管線挖埋回填區域鋪面強度檢驗之研究」,國立臺灣大學土木工程學系碩士論文,臺北。
施盛耀,(2010),「冷拌多孔性瀝青混凝土之工程性質」,國立成功大學土木工程學系碩士論文,臺南。
徐聖博,(2015),「發泡瀝青技術添加瀝青刨除料應用於道路底層可行性之研究」,國立中央大學土木工程學系碩士論文,桃園。
郭俊宏,(2017),「以ETC大數據結合FWD建立台灣區高速公路鋪面結構評估準則之研究」,國立中央大學土木工程學系碩士論文,桃園。
曾偉原,(2016),「冷拌再生瀝青混凝土應用於管線挖掘回填層之可行性研究」,國立中央大學土木工程學系碩士論文,桃園。
游景年,(2017),「冷拌再生瀝青混凝土應用於道路管線挖掘回填工程之現地驗證」,國立中央大學土木工程學系碩士論文,桃園。
簡啓倫,(2019),「冷拌再生乳化瀝青混凝土應用於鋪面底層之可行性評估」,國立中央大學土木工程學系碩士論文,桃園。
AASHTO PP 94. (2018). “Standard specification for determination of optimum asphalt content of cold recycled mixture with foamed asphalt.” Group 3.
AASHTO MP 38. (2018). “Standard specification for mix design of cold recycled mixture with foamed asphalt.” Group 3.
Al-Amoudi, O. S. B., Asi, I. M., Wahhab, A., & Khan, Z. A. (2002). “Clegg Hammer—California-Bearing Ratio Correlations.” Journal of Materials in Civil Engineering., Vol. 14, No.6, pp.512-523.
Asphalt Recycling & Reclaiming Association. (2017). “Recommended mix design guidelines for cold recycling using foamed (expanded) asphalt recycling agent.” CR202.
George, V., Rao, N. Ch., & Shivashankar, R. (2014). “PFWD, DCP and CBR correlations for evaluation of lateritic subgrades.” International Journal of Pavement Engineering., Vol. 10, No.3, pp.189–199.
Guthrie, W. S., Reese, G. B. (2008). “Assessing Rutting Susceptibility of Cement-Treated Base Material under Early Trafficking with Heavy Clegg Impact Soil Tester.” Journal of the Transportation Research Board, 2059(1), pp.72–79.
Martinez-Arguelles, G., Giustozzi, F., Crispino, M., & Flintsch, G. W. (2015). “Laboratory investigation on mechanical performance of cold foamed bitumen mixes: Bitumen source, foaming additive, fiber-reinforcement and cement effect.” Construction and Building Materials., 93, pp.241-248
Hailesilassie. B. W., Schuetz, P., Jerjen, I., Hugener, M., & Partl M. N. (2015). “Dynamic X-ray radiography for the determination of foamed bitumen bubble area distribution.” Journal of Materials Science., pp.79-92.
Iwański, M., Chomicz-Kowalska, A. (2013). “Laboratory study on mechanical parameters of foamed bitumen mixtures in the cold recycling technology.” Procedia Engineering. 57, pp.433-442.
Lin, J., Hong, J., & Xiao, Y. (2017). “Dynamic characteristics of 100% cold recycled asphalt mixture using asphalt emulsion and cement.” Journal of Cleaner Production, 156, pp. 337-344.
Lin, J., Wei, T., Hong, J., Zhao, Y., & Liu, J. (2015). “Research on development mechanism of early-stage strength for cold recycled asphalt mixture using emulsion asphalt.” Construction and Building Materials, 99, pp. 137-142.
Kuna, K., Airey G., & Thom N. (2014). “Laboratory mix design procedure for foamed bitumen mixtures.” Journal of the Transportation. Research Board 2444, pp.1-10.
Ma, T., Wang, H., Zhao, Y., Huang, X., & Pi, Y. (2015). “Strength mechanism and influence factors for cold recycled asphalt mixture.” Advances in Materials Science and Engineering.
Nagato, A. (2010). “The history and application examples of portable FWD in Japan.” Belgian Road Research Centre. 6th European FWD User Group Meeting, Belgian.
Sangiorgi, C., Tataranni, P., Simone, A., Vignali, V., Lantieri, C., & Dondi, G. (2017). “A laboratory and filed evaluation of Cold Recycled Mixture for base layer entirely made with Reclaimed Asphalt Pavement.” Construction and Building Materials, 138., pp. 232-239.
Wirtgen GmbH. (2010). “Wirtgen Cold Recycling Manual.” 3th Edition, ISBN
3-936215-05-7, Windhagen, Germany.
Wirtgen GmbH. (2012). “Wirtgen Cold Recycling Manual.” 1st Edition, Windhagen, Germany.
Xu, J., Huang, S. C., Qin, Y. C., & Li, F. (2011). “The impact of cement contents on the properties of asphalt emulsion stabilized cold recycling mixtures.” International journal of pavement research and technology, 4(1), pp. 48-55.
Yan, J., Leng, Z., Li, F., Zhu, H., & Bao, S. (2017). “Early-age strength and long-term performance of asphalt emulsion cold recycled mixes with various cement contents.” Construction and Building Materials, 137, pp. 153-159.