跳到主要內容

簡易檢索 / 詳目顯示

回結果列表
研究生： 鄭曳辰
zheng ye
論文名稱： FRP筋混凝土梁撓曲行為探討
Analytical Study on Flexural Behavior of FRP Reinforced Concrete Beams
指導教授： 王勇智
Yung-Chih Wang
口試委員:
學位類別： 碩士
Master
系所名稱： 工學院 - 土木工程學系
Department of Civil Engineering
畢業學年度： 98
語文別： 中文
論文頁數： 94
中文關鍵詞： 握裹滑移 、撓曲 、FRP筋 、layer-by-layer斷面分析
外文關鍵詞： bond slip, flexure, FRP bars, layer-by-layer sectional analysis
相關次數： 點閱：10  下載：0 
分享至:
查詢本校圖書館目錄 查詢臺灣博碩士論文知識加值系統 勘誤回報

    • 本研究將使用分層(layer-by-layer)斷面彎曲曲率分析方法，模擬FRP筋混凝土梁彎曲與曲率之曲線，藉此了解FRP筋梁之撓曲行為。文中，亦以實驗與模擬結果進行比對。實驗試體共有十一根梁，和其他文獻試體進行模擬分析，藉此比較鋼筋梁與FRP筋梁受撓曲破壞下，其撓曲行為的不同。實驗結果發現，FRP筋滑移問題較普通鋼筋明顯，會影響預測FRP筋梁之彎矩與曲率的準確性。

    The target of the research is to study the flexural behavior of FRP reinforced concrete beams by means of sectional analysis and experimental verification. The sectional analysis is made via layer-by-layer method. The experimental work is provided to verify the availability of the traditional section analysis. Eleven reinforced concrete beams reinforced with FRP and steel bars are tested. The predict specimens included test beams by flexural failure in the study and other beams in references. The comparison between tested and predicted results on flexure behavior was made. The results show that the FRP bars slip effect is more obvious than steel bars, which may affect the accuracy of prediction.

    一、前言…………………………………………………………………1 二、文獻回顧……………………………………………………………2 2-1 FRP筋混凝土梁之撓曲行為預測……………………………2 2-2 FRP筋壓力貢獻………………………………………………5 2-2-1直接軸壓試驗…………………………………………5 2-2-2 使用於構件的抗壓貢獻………………………………6 2-3 ACI-440在FRP筋伸展長度規定 …………………………8 三、撓曲行為預測模型建立 …………………………………………10 3-1 分層斷面彎矩曲率模型 ……………………………………10 3-2 握裹滑移模型 ………………………………………………13 四、FRP筋梁實驗 ……………………………………………………15 4-1 試體製作 ……………………………………………………15 4-1-1材料性質測驗 …………………………………………15 4-1-1-1混凝土…………………………………………15 4-1-1-2 鋼筋直接拉力試驗 …………………………15 4-1-1-3 #7CFRP筋拉力試驗 …………………………16 4-1-2 試體梁詳圖說明………………………………………17 4-2 試驗設置………………………………………………………19 4-3 試驗結果………………………………………………………20 4-4 試驗結果與初期預測比較……………………………………22 4-4-1 RC梁行為 ………………………………………………22 4-4-2 FRP筋梁行為……………………………………………23 4-4-2-1 FRP筋混凝土梁壓力破壞試體 ………………23 4-4-2-2 FRP筋混凝土梁拉力破壞試體 ………………26 4-5 FRP筋壓筋貢獻 ……………………………………………28 五、量測與預測結果比較與討論 ……………………………………29 5-1 FRP筋梁設計理念……………………………………………29 5-2 試體主筋握裹滑移評估………………………………………31 5-3 FRP筋滑移模式探討 …………………………………………33 5-3-1實驗數據統計……………………………………………33 5-3-2滑移模式擬略……………………………………………34 5-3-3 其他實驗數據驗證 ……………………………………37 六、結論 ………………………………………………………………38 6-1結論 ……………………………………………………………38 6-2建議 ……………………………………………………………39參考文獻 ………………………………………………………………40

    1. 洪一德，「FRP筋混凝土梁設計與實驗印證」，國立中央大學，碩士論文，民國97年。
    2. ACI Committee 440, Guide for the Design and Construction of Structural Concrete Reinforced with FRP Bars, American Concrete Institute, 2006.
    3. Safaan, M.M., “Mechanical properties of locally produced hybrid FRP bars as concrete reinforcement”, International Conference : Future Vision and Challenges for Urban Development, pp. 1-13, Cairo, Egypt, December 2004.
    4. Maria, A. A., “A General Method for Deflection Evaluation of Fiber Reinforced Polymer (FRP) Reinforced Concrete Members”, The FRP Retrofit Experts, pp.1-10, University of Lecce, Italy, 2002.
    5. Joseph, R.Y. Shawn, P.G., and David, W.D., “Effective Moment of Inertia for Glass Fiber-Reinforced Polymer-Reinforced Concrete Beams”, ACI Structural Journal, Vol. 100, No. 6, pp.732-739, 2003.
    6. Muhammad, M.R., and Ali N., “Evaluation of ACI 440 Deflection Model for Fiber-Reinforced Polymer Reinforced Concrete Beams and suggested Modification”, ACI Structural Journal, Vol. 106, No. 6, pp.762-771, 2009.
    7. Gravina, R.J., and Smith, S.T., “Flexural behaviour of indeterminate concrete beams reinforced with FRP bars”, Engineering Structures, Vol. 30, pp2370-2380, 2008 .
    8. Deitz, D. H., Harik, I. E., and Gesund H., “Physical Properties of Glass Fiber Reinforced Polymer Rebars in Compression”, Journal of Composites for Construction, Vol. 7, No. 4, pp.363-366, 2003.
    9. Wu, W. P., “Thermomechanical Properties of Fiber Reinforced
    Plastics (FRP) Bars,” West Virginia University, U.S.A., PhD thesis, 292 pp., 1990.
    10. Kobayashi, K., and Fujisaki, T., “Compressive Behavior of FRP Reinforcement in Non-Prestressed Concrete Member”, Proceedings of the second International RILEM Symposium on Non-metallic (FRP) Reinforcement for Concrete Structure, pp. 267-274, Ghent, Belgium, 1995.
    11. Mallick, P. K., Fiber Reinforced Composites, Materials, Manufacturing, and Design, Marcell Dekker, New York, 1988.
    12. Gong, Y., “Research Progress of FRP Reinforced Concrete Column,” Architecture Technology, Vol. 37, No. 11, pp. 836-838, 2006.
    13. Nanni.A., “Relevant Applications of FRP Composites in Concrete Structures”, Composites in Construction, Porto, Portugal, October 2001.
    14. Paramanantham, N., “ Investigation of the Behavior of Concrete Columns Reinforced with Fiber Plastic Rebar”, MS thesis, Lamar University, U.S.A., 183 pp., 1993.
    15. Benmokrane, B., Zhang, B., and Chennouf, A., “Tensile properties and pullout behavior of AFRP and CFRP rods for grouted anchor applications ”, Journal of Construction and Building Materials, Vol. 14, No. 3, pp. 157, 2000.
    16. CNS 560 A2006，鋼筋混凝土用鋼筋規範，經濟部國家標準檢驗局，民國95年。
    17. ACI Committee 318, Building Code Requirements for Structural Concrete, American Concrete Institute, 2005.
    18. Houssam A., Toutanji, and Mohamed Saafi, “Flexural Behavior of Concrete Beams Reinforced with Glass Fiber-Reinforced Polymer (GFRP) Bars”, ACI Structural Journal, Vol. 97, No.5, pp712-719 , 2000.
    19. Pecce. M., Manfredi. G., and Cosenza. E., “Experimental Response and Code Models of GFRP RC Beams in Bending”, Journal of Composites for Construction, Vol. 4, No. 4, pp182-pp189, 2000.

    QR CODE
    :::