簡易檢索 / 詳目顯示
| 研究生： |
郭明珠 Ming-Zhu Guo |
|---|---|
| 論文名稱： |
類神經網路於切換式磁阻馬達轉矩漣波控制之應用 |
| 指導教授： |
徐國鎧
Kuo-Kai Shyu |
| 口試委員: | |
| 學位類別： |
碩士 Master |
| 系所名稱： |
資訊電機學院 - 電機工程學系 Department of Electrical Engineering |
| 畢業學年度： | 88 |
| 語文別： | 中文 |
| 論文頁數： | 79 |
| 中文關鍵詞： | 切換式磁阻馬達 、類神經網路 、轉矩漣波 |
| 相關次數： | 點閱：8 下載：0 |
| 分享至: |
| 查詢本校圖書館目錄 查詢臺灣博碩士論文知識加值系統 勘誤回報 |
本論文以定點式單晶片數位信號處理器(digital signal processor, DSP)實現切換式磁阻馬達類神經漣波控制方法之驅動器。
切換式磁阻馬達常因換相時會產生轉矩漣波，所以本文利用類神經控制方法提出切換式磁阻馬達換相角度自適調整方法。全數位化控制器的實現可使得系統的複雜度大為降低及提高可靠度，由於單晶片數位信號處理器具有低成本與快速運算之能力，所以本文將使用TMS320F240實現全數位化轉矩漣波消除控制之切換式磁阻馬達驅動系統，並利用類神經網路調整提前導通的角度，針對轉矩漣波的降低加以模擬和實驗驗證。
[1] H. van der Broeck, D. Gerling, E. Bolte, “Switched reluctance drive and PWM induction motor drive compared for low cost application,” The European Power Electronics Association, pp. 71-76, 1993.
[2] M. T. DiRenzo, “Switched Reluctance Motor Control-Basic Operation and Example Using the TMS320F240,” TI DSPS Research and Development Center Application Report, February 2000.
[3] I. Husain and M. E. Elbukuk, “Energy Efficient C-Dump Converters for Switched Reluctance Motors,” IEEE Trans. on Power Electronics, vol. 12, no. 5, pp. 912-921, September 1997.
[4] M. Ehsani, I. Husain, K. R. Ramani, and James H. Galloway, “Dual-Decay Converter for Switched Reluctance Motor Drives in Low-Voltage Applications,” IEEE Trans. on Power Electronics, vol. 8, no. 2, pp. 224-230, April 1993.
[5] TMS320C24x DSP Controllers Reference Set, Texas Instruments, 1997.
[6] TMS320C24x DSP Controllers Evaluation Module Technical Reference Set, Texas Instruments, 1997.
[7] TMS320F20x/F24x DSP Embedded Flash Memory Technical Reference, Application Report Literature Number: Spru282, Texas Instruments, 1998.
[8] TMS320C1x/C2x/C2xx/C5x Assembly Language Tools User’s Guide, Texas Instruments, 1995.
[9] TMS320C2xx C Source Debugger User’s Guide, Texas Instruments, 1995.
[10] TMS320C2x/C2xx/C5x Optimizing C Compiler User’s Guide, Texas Instruments, 1995.
[11] K. M. Rahman, A. V. Rajarathnam, and M. Ehsani, “Optimized Instantaneous Torque Control of Switched Reluctance Motor by Neural Network,” IEEE Industry Application Socirty Annual Meeting, New Orleans, Louisiana, October 5-9, pp. 556-563, 1997.
[12] J. S. Chang, R. Donald, and W. Barry, “Adapting CMAC Neural Networks with Constrained LMS Algorithm for Efficient Torque Ripple Reduction in Switched Reluctance Motors,” IEEE Trans. on Control Systems Technology, vol. 7, no. 4, pp. 401-413, July 1999.
[13] S. Chen, C. F. N. Cowan, and P. M. Grand, “Orthogonal least square learning algorithm for radial basis function networks,” IEEE Trans. Neural Networks, vol 2, pp. 302-309, 1991.
[14] 葉怡成，類神經網路模式應用與實作，儒林，1993。
[15] Simon Haykin, Neural Networks, Prentice Hall International, 1999.
[16] A. M. Hava and V. Blasko, “ Modified C-Dump Converter for Variable-Reluctance Machines,” IEEE Trans. on Ind. Appl., vol. 28 no. 5, pp.1017-1022, Sep./Oct. 1992.
[17] I. Husain and M. Ehsani, “Torque Ripple Minimization in Switched Reluctance Motor Drives by PWM Current Control,” IEEE Trans. on Power Elec., vol. 11, no. 1, pp.83-88, 1996.
[18] J. P. Lyons, S. R. Macminn and M. A. Preston, “Flux/Current Methods for SRM Rotor Position Estimation,” IEEE.IAS Annu. Meet. Dearborn, MI, pp.482-487, Oct. 1991.
[19] P. P. Acarnley, R. J. Hill and C. W. Hooper, “Detection of Rotor Position in Stepping and Switched Motors by Monitoring of Current Waveforms,” IEEE Trans. on Ind. Elec., vol. IE-32 no. 3, pp.215-222, August 1985.
[20] C. Y. Huang, T. C. chen, C. L. Huang, “Robust control of induction motor with a neural-network load torque estimator and a neural-network identification,” IEEE Trans. on Ind. Electronics, Vol. 465, pp. 990-998, Oct. 1999.
[21] Lee, Chow, Cheng, “DC servo motor controllers based on a neural network,” Intelligent Systems Engineering First International Conference on Conf. Publ. No. 360, pp. 287-292, 1992.
