本文鑑於傳統之充電電荷泵浦（Charge Pump）其調壓控制困難且複雜，提出將電感結合充電電荷泵浦之可調節式升壓型直流-直流轉換器設計，基於充電電荷泵浦之基礎加入電感器設計，結合切換式轉換器（Switching Converter）架構之優點，使其大幅提高線性調節度與轉換效率，在架構上簡化控制器設計之複雜度，並透過詳盡計算分析，使架構之各項參數與規格可透過公式計算得知，以增加本架構於應用時之便利性。最後以模擬和實際製作電路，驗證本電路確實可行且具其效果。
本文提出之電路架構改善直流轉換器之兩項重要參數-效能(最大可達 97.5%)與負載調節度(0.76mV/mA)，此外電壓轉換比例可由責任週期調整，不再受限於電路架構，使控制更直覺以及大幅降低設計之複雜度。

The charge pump circuits are usually not regulated in the past, or detect the current of the capacitance be a feedback signal. That is difficult to make controller and can’t get higher efficiency and need more current detector. To enhance the accuracy and the stability, this thesis presented a novel design of step up regulated charge pump which coupled inductor and design the feedback circuit by an un-complex voltage feedback to control the charging duty retio. The power efficiency also can be improvement by the new topology. As a result, the battery life can be increased, which makes charge pump more attractive.
The measured results show that the input voltage indeed can be step up to the desired output voltage. The new structure improves the efficiency(97.5%)、load regulation(0.76mV/mA) of the charge pump circuit. Furthermore, the regulated scheme makes the voltage conversion ratio no longer predetermined by the converter topology, and can be varied by adjusting the duty ratio.

[1] A.K.P Viraj and G.A.J Amaratunga, “A Monolithic CMOS 5V/1V Switched Capacitor DC-DC Step-down Converter,” IEEE PESC, pp. 2510-2514, June 2007.
[2] Y.W. Lu, G. Feng, Y.F. Liu, “A Large Signal Dynamic Model for DC-to-DC Converters with Average Current Control,” IEEE APEC ‘04, vol. 2, pp. 797-803.
[3] L. Pylarinos, “Charge pumps: an overview,” University of Toronto, Tutorial Papers on Analog Circuits, 2002.
[4] J.F. Dickson, “On-chip High-Voltage Generation in NMOS Integrated Circuits Using an Improved Voltage Multiplier Technique,” IEEE Journal of Solid-State Circuits, Vol. 11, No. 6, pp. 374-378, 1976.
[5] J.T. Wu and K.L. Chang, “MOS charge pumps for low-voltage operation,” IEEE Journal of Solid-State Circuits, Vol. 33, pp. 592-597, 1998.
[6] M.S. Makowski, “Realizability conditions and bounds on synthesis of switched-capacitor DC-DC voltage multiplier circuits,” IEEE Transactions on Circuits and Systems I: Fundamental Theory and Applications, Vol. 44, pp. 684-691, 1997.
[7] J.A. Starzyk, Y. W. Jan and F. Qui,“A DC-DC charge pump design based on voltage doublers,” IEEE Transactions on Circuits and Systems I: Fundamental Theory and Applications, Vol. 48, pp. 350-359, 2001.
[8] B.Kormann and J. Pelfrey, “Simple design of an ultra-low-ripple dc/dc boost converter with TPS60100 charge pump,” Journal of Analog Applications, Texas Instruments Literature, No. SLYT015, pp. 15-18, 2000.
[9] B.Kormann and J. Pelfrey, “High-efficiency, regulated charge pumps for high-current applications,” Texas Instruments Power Supply Design Seminars, 2001.
46
[10] C.C. Wang and J.C. Wu, “Efficiency improvement in charge pump circuits,” IEEE Journal of Solid-State Circuits, Vol. 32, pp. 852-860, 1997.
[11] W.H. Ki, F. Su and C.Y. Tsui, “Charge redistribution loss consideration in optimal charge pump design,” in proceedings of the IEEE International Symposium of Circuits and Systems, Vol. 2, pp. 1895-1898, 2005.
[12] A. Saiz-Vela, P. Miribel-Catala, J. Colomer, M. Puig-Vidal and J. Samitier, “Accurate design of Two-Phase Voltage Doublers based on a compact mathematical model,” in proceedings of the IEEE International Symposium of Circuits and Systems, pp. 213-216, 2007.
[13] L. Shir-Kuan, ＂Design and Implementation of Boost Charge Pump Circuit of Energy Harvesting System,＂NCTU MS., Thesis, 2009.
[14] B.Robert Gregoire, “A Compact Switched-Capacitor Regulated Charge Pump Power Supply,” IEEE J. Solid-State Circuits, vol. 41, no. 8, pp. 1944-1953, Aug. 2006.
[15] J.-J. Huang,“Implementation of Series Equalization by Switching Capacitor for Hybrid Battery System＂NCU MS., Thesis, 2011.