| 研究生: |
張永生 Yung-Sheng Chang |
|---|---|
| 論文名稱: |
柔性鋪面之績效評估與非均佈荷重效應 The performance-based pavement evaluation and effect of non-uniform contact stresses on flexible pavement |
| 指導教授: |
張瑞宏
Jui-Hung Chang |
| 口試委員: | |
| 學位類別: |
碩士 Master |
| 系所名稱: |
工學院 - 土木工程學系 Department of Civil Engineering |
| 畢業學年度: | 90 |
| 語文別: | 中文 |
| 論文頁數: | 101 |
| 中文關鍵詞: | 接觸應力 、車轍 、開裂 、瀝青混凝土 |
| 外文關鍵詞: | contact stress, rutting, cracking, asphalt concrete |
| 相關次數: | 點閱:9 下載:0 |
| 分享至: |
| 查詢本校圖書館目錄 查詢臺灣博碩士論文知識加值系統 勘誤回報 |
摘要
本研究所討論的內容分成二大部份,一是鋪面績效評估,另一是探討非均佈荷重所造成之影響,分別說明如下:
在路面績效評估方面,本研究以三維有限元素鋪面結構分析模式,根據中山高速公路軸重調查,分析中山高速公路斷面在交通載重下的鋪面結構反應,並且以應變狀態做為路面績效評估時破壞準則的依據。分析結果與AASHTO設計準則建議值比較下顯示,損害普遍較AASHTO以服務指數經驗方法估算之損害程度為高,依AASHTO設計法設計之路面會低估交通載重對鋪面之損害,而可能發生較設計年限提早破壞的情形。
在探討非均佈荷重之影響方面,本研究所以輪胎模型模擬出輪胎與鋪面表面的接觸應力,分析不同打氣胎壓與單軸雙輪載重作用下對鋪面的反應。分析結果顯示,鋪面的表面開裂將可能發生雙輪中央處;而鋪面的表面車轍將可能發生在接近輪胎邊緣處,並且破壞與重車的高胎壓、高軸重有關。在以均佈荷重作用於柔性鋪面上,並無法模擬出鋪面表面的反應,只有非均佈載重可以模擬出真實鋪面反應。
ABSTRACT
This study consists of two parts. One is performance-based pavement evaluation; the other is the influence of tire-pavement non-uniform contact stresses.
In the part of performance-based pavement evaluation, this study developed a 3-dimensional finite element model in calculating pavement response under traffic loading. The effects of the Sun Yat-Sen Freeway section on pavement damage caused by traffic loading are analyzed. The results show that, by compare is with AASHTO design guide, the AASHTO equivalent axle load factor used to design tends to underestimate the pavement damage.
In the influence of tire-pavement non-uniform contact stresses, this study developed a tire model to model tire-pavement non-uniform contact stresses. The results show that, the surface crack occurred center of two tires; and the surface rutting occurred at the near tire edge. The distress relates with high tire pressure and axle load. The tire-pavement uniform contact stress can’t model the response of surface on pavement, only non-uniform contact stress can.
參考文獻
1.de Beer, M., C. Fisher, and F. Jooste. “Determination of Pneumatic Tyre/Pavement Interface Contact Stresses Under Moving Loads and Some Effects on Pavement With Thin Asphalt Surfacing Layer,” Proceedings of the Eighth International Conference on Asphalt Pavements, Seattle, Washington, 1997, pp. 179-226.
2.Huang, Y. H., Pavement Analysis And Design, Prentice Hall, Englewood Cliffs, N. J., (1993).
3.Hudson, S. W., and Seeds, S.B., “Evaluation of increased pavement loading and tire pressures ”, Transportation Research Record 1207, pp. 197-206 (1988).
4.Sebaaly, P. E., and Tabatabaee, N., “Effect of tire parameters on pavement damage and load-equivalency factors ,” Journal of Transportation Engineering, ASCE, Vol. 118, No. 6, pp. 805-819 (1993).
5.Kim, O. K., Bell, C. A., and Wilson, J. E., “Effect of increased truck tire pressure on asphalt concrete pavement,” Journal of Transportation Engineering, ASCE, Vol. 115, No. 4, pp. 329-350 (1989).
6.廖溪坤,「材料對石膠泥瀝青混凝土成效特性影響之研究」,碩士論文,國立中央大學土木工程研究所,桃園(1999)。
7.吳俊杰,「礦物添加物對石膠泥瀝青混凝土疲勞行為之影響」,碩士論文,國立中興大學土木工程研究所,臺中(1999)。
8.AI, Research and Development of the Asphalt Institute’s Thickness Design Manual (MS-1), 9th edition, Research Report 82-2, Asphalt Institute (1982).
9.Shell, Shell Pavement Design Manual- Asphalt pavements and Overlays for Road Traffic, Shell International Petroleum, London (1978).
10.Barker, W.R. and W.N. Brabston, Development of a Structural Design Procedure for Flexible Airport Pavement, FAA Report No. FAA-RD-74-199, U.S. Army Corps of Engineers Waterways Experiment Station, Federal Aviation Administration (1974).
11.黃偉慶、宋侑玪,「本土化柔性鋪面設計之重車與胎壓考量」,國立中央大學土木工程研究所,桃園(2001)。
12.American Association of State Highway and Transporation Officials, Guide for Design of Pavement Structures (VolumeⅠ), AASHTO (1986,1993).
13.Zaghloul S. and T.White, Use of Three-Dimensional, Dynamic Finite Element Program for Analysis of Flexible Pavement, TRR1388, Transportation Research Record, 1992, pp.60-69.
14.PCA, Thickness Design for Concrete Highway and Street Pavements, Portland Cement Association (1984).
15.Gerritsen, A.H., van Gurp, C.A.P.M., van der Heide, J.P.J., Molenaar, A.A.A., andPronk, A.C., “Prediction and Prevention of Surface Cracking in Asphaltic Pavements,” 6 th International Conference Structural Design of Asphalt Pavements,The University of Michigan, Ann Arbor, Michigan, July 1987, p.378-391.
16.Dauzats, M. and Rampal, A., “Mechanism of Surface Cracking in Wearing Courses,” Proceedings 6th International Conference Structural Design of Asphalt Pavements,The University of Michigan, Ann Arbor, Michigan, July 1987, p. 232-247.
17.Nunn, M., “Design of Long-Life Roads for Heavy Traffic,” Proceedings, Industry Conference, Australian Asphalt Pavement Association, Surfers Paradise, Queensland, Australia, 1998.
18.Myers, L.A., Roque, R., and Ruth B.E., “Mechanisms of Surface-Initiated Longitudinal Wheel Path Cracks in High-Type Bituminous Pavements,” Proceedings, Volume 67, Association of Asphalt Paving Technologists, 1998.
19.Myers, L., Roque, R., Ruth, B., and C. Drakos. “Measurement of Contact Stresses for Different Truck Tire Types to Evaluate Their Influence on Near-Surface Cracking and Rutting,” Transportation Research Record No. 1655, Transportation Research Board (TRB), National Research Council, Washington, D.C., 1999, pp. 175-184.
20.Himeno, K., Ikeda, T., Kamijima, T., and Abe, T., “Distribution of Tire Contact Pressure of Vehicles and Its Influence on Pavement Distress,” Proceedings, 8th International Conference on Asphalt Pavements, University of Washington, Seattle, Washington, August 1997, p. 129-139.
21.Weissman, S.L., “The Influence of Tire-Pavement Contact Stress Distribution on the Development of Distress Mechanisms in Pavements,” Symplectic Engineering Corporation, Transportation Research Record No. 510 (1999).
22.Reddy, J.N., Finite Element Method, McGraw-Hill, London, (1993).
23.馮天正,「三維有限元素應用於柔性鋪面之非線性分析」,國立中央大學土木工程研究所,碩士論文,桃園(2000)。
24.陳一昌、吳學禮、房性中,「中山高速公路新竹至員林段拓寬工程柔性路面厚度設計研討」,1995年中美斐柔性路面厚度設計研討會專輯(二),台北(1995)
25.Jones, A., “Tables of Stresses in Three-Layer Elastic Systems,” Buletin 342, Highway Research Board, pp. 176-214 (1962).
26.ABAQUS Example Problems Manual (VolumeⅡ), Version 6.1-1, Hibbitt, Karlsson & Sorensen, Inc. (2000).
27.http://www.bridgestone.com.tw/page/product/produtin.html,台灣普利司通股份有限公司, (2002)
28.ABAQUS Theory Manual, Version 6.1-1, Hibbitt, Karlsson & Sorensen, Inc. (2000).
29.AASHTO, Guide for Design of Pavement Structures, American Association of State Highway and Transportation Officials (1986, 1993).
30.Southgate H. F. and Deen R. C., “Effects of Load Distribution and Axle and Tire Configurations on Pavement Fatigue,” UKTRP-85-13, May 1985, Kentucky Transportation Research Program, University of Kentucky.