| 研究生: |
謝昭平 Chao-Ping Hsieh |
|---|---|
| 論文名稱: |
剖風儀之關鍵零組件-低雜訊放大器之研製 Key component of wind profiler-the develop of LNA |
| 指導教授: |
丘增杰
Tsen-Chieh Chiu |
| 口試委員: | |
| 學位類別: |
碩士 Master |
| 系所名稱: |
資訊電機學院 - 電機工程學系 Department of Electrical Engineering |
| 畢業學年度: | 92 |
| 語文別: | 中文 |
| 論文頁數: | 48 |
| 中文關鍵詞: | 低雜訊放大器 、剖風儀 、共平面波導 |
| 外文關鍵詞: | Wind Profiler, LNA, CPW |
| 相關次數: | 點閱:10 下載:0 |
| 分享至: |
| 查詢本校圖書館目錄 查詢臺灣博碩士論文知識加值系統 勘誤回報 |
本論文主要探討共平面波導不連續(Discontinuity)的結構特性,應用不連續結構等效之集總元件,設計剖風儀(Wind Profiler)低雜訊放大器之匹配網路。由於剖風儀使用之低雜訊放大器數量繁多,共平面結構可以簡化設計與製作的程序。使用印刷電路板製作可以減少製作的誤差,提高低雜訊放大器特性的一致性。
本文中使用IE3D完成共平面波導不連續結構模擬,使用ADS電路模擬軟體設計出不連續結構的等效電路與低雜訊放大器,並以FR4基板實現共平面波導不連續結構與低雜訊放大器。比較模擬與實作結果的一致性,確認共平面波導不連續結構特性以完成低雜訊放大器的阻抗匹配。
In the thesis, the characteristics of coplanar waveguide(CPW) discontinuities are studied and applied on the matching networks of low noise amplifiers(LNA) at 1.3 GHz. First, the LNA is designed using ADS software. In the design, all the components are lumped elements. Then, all the lumped components are replaced with CPW discontinuities as much as possible. The circuital values corresponding to the CPW discontinuities are obtained using IE3D electromagnetic simulation software. All the designs are verified by measurements. The simulation and measurement results are in good agreement.
[1] V.L. Peterson, WIND PROFILING:The History, Principles, and Application of Clear-Air Doppler Radar, Tycho Technology, Inc., 1988.
[2] R.N. Simons, Coplanar Waveguide Circuits, Components, and Systems, John Wiley & Sons, Inc., 2001.
[3] D.M. Pozar, Microwave Engineering, second Ed., John Wiley & Sons, Inc., 1998.
[4] 高銘鴻, “共平面波導集總元件設計, “ 碩士論文,國立中央大學, 2003.
[5] A.K. Sharma and H. Wang, “Experimental Models of Series and Shunt Elements in Coplanar MMICs, “ IEEE MTT-s Int. Microwave Symp. Dig., Vol. 3, pp.1349-1352, June 1-5, Albuquerque, NM, 1992.
[6] “Low Noise Enhancement Mode Pseudomorphic HEMT in a Surface Mount Plastic Package,” Agilent data sheet, ATF-54143, Agilent Technologies, Inc., 2003.
[7] “E-pHEMT GaAs FET Low Noise Amplifier Design for 1.575 GHz GPS Applications,“ Application Note 1376, Agilent ATF-55143 ,Agilent Technologies, Inc., 2003.
[8] “In-fixture Microstrip Device Measurements Using TRL* Calibration,” Product Note PN 8720-2, Product Note PN 8720-2, Agilent Technologies, Inc., 2000.
[9] C.J. Georgopoulos, RF and Mircowave Matching Tehcniques, Interference Control Technologies, Inc., 1990.
[10] K.C. Gupta, R. Garg, I. Bahl and P. Bhartia, Microstrip Lines and Slotlines, Second Edition, Artech House, 1996.
[11]T.C. Edwards and M.B. Steer, Foundations of Interconnect and Microstrip Design, Third Edition, John Wiley & Sons, Inc., 2000.
[12]IE3D version 9.0, Zeland Sofware Inc., 2002
[13]ADS version 2002, Agilent Inc., 2002